Thinking about adding a skylight? The biggest concern is always leaks. Here's why ours don't leak: we build a structural curb between the rafters, wrap it in ice-and-water shield, install step flashing on all four sides, and re-shingle around the unit with proper overlap. Then we verify the seal from inside the attic. Washington Boro Roofing & Maintenance — leak-free skylight installation in Washington Boro.
We install deck-mounted skylights and curb-mounted skylights. Deck-mounted units sit flush against the roof deck and work best for shingle roofs on standard pitch. Curb-mounted units sit on a raised frame and work on flat or low-slope roofs. Both types get the same flashing treatment: ice-and-water shield, step flashing, counter-flashing, and sealant at every transition.
Our Skylight Installation Process
Site Assessment
We assess your roof from above and inside the attic. We locate the trusses and rafters, check the roof deck sheathing condition, and identify the best skylight placement for natural light based on sun angle, room layout, and roof pitch.
Curb Construction
Precise opening cut through the roof deck. Structural curb framed between trusses with load-bearing headers. Every cut edge of the sheathing sealed. The curb is the structural foundation — we don't skimp on the framing.
Seal Integration
Full flashing system: ice-and-water shield base layer, step flashing and counter-flashing on all four sides, woven into the existing shingle field. Water flows over the flashing and onto the shingles below — never behind them.
Install & Insulate
Unit installed and sealed. Light shaft insulated and trimmed. We verify the seal from inside the attic — if we can see any daylight at the flashing joints, we re-seal before we leave. Your skylight is watertight and energy-efficient.
What Washington Boro Customers Say
"From the first phone call to the final walkthrough, everything was seamless. The team was courteous and efficient. Already recommended them to two friends."
"After getting several quotes, these guys stood out with their honesty and knowledge. No pressure, just straightforward advice and excellent workmanship."
"Our neighbors recommended them and now we understand why. Meticulous attention to detail and they treated our home like it was their own."
Why Choose Washington Boro Roofing & Maintenance for Skylight Installation?
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.
Roofer-Installed, Not Handyman
Washington Boro Roofing & Maintenance is a roofing contractor, not a general handyman. Skylights are roof penetrations — they require roofing expertise, proper flashing materials, and waterproofing knowledge. That's what we do every day.
Leak-Free Guarantee
Every skylight gets ice-and-water shield, step flashing on all four sides, counter-flashing, and sealant at every transition. Verified from inside the attic before we leave. If it leaks, we fix it free.
Structural Curb Framing
We frame a proper structural curb between your rafters with doubled headers. No flimsy brackets or foam shims. The curb carries the skylight load and provides a solid base for the flashing system.